Australian C - Tick

release time :2021-12-24 15:02:45

1 Introduction
C - TICK Australian EMC is part of the authentication , the Australian Communications Authority ( Austra1ian , hereinafter referred to as ACA ) controls only the interference
part of the control , the control range of products from 1999 . 1 / 01 is enforced .
The electrical safety requirements :
In Australia , the Electrical Safety Conformity assessment is the responsibility of local government , each department uses the " Electrical Safety Act 1945 " Mutual recognition
of architecture ( Approva1s ) . This would open up an electrical product is divided into the announcement ( Dec1ared ) and non - announcement ( notice ) in the products shall
conform to relevant safety standards of Australia , and acquires the state of the competent authority approval certificate
Non - Announcement of electrical and electronic equipment without authentication but direct sales , retailers , manufacturers and importers must ensure that such electrical safety
EMC requirements
Australia ' s requirements of EMC with EMC architecture ( 1992 ) of the radio communication method in this way self - declared schema range of electrical products shall comply
with the requirements of Australian Standards , and acquired the Australian companies approved to use the C - flag .
If the product at the same time comply with electrical safety and EMC requirements , he or she can apply to the Regulatory Compliance Mark ( RCM )

2 . The approval mark

3 Technical Information
voltage : AC240V
frequency : 50Hz

4 product range
electronics application is generally C - Tick , communications products are generally application - A Tick , but if the products were A - Tick , it is not necessary to compare the application C - Tick
in addition to the three - phase power supply of medical products and electronic and electrical products , electrical and electronic products are designed by KPL
business scope

5 Factory inspection
does not require factory inspection

6 Instruction for authentication
any safety sign of the product obtained in Australia , New Zealand have been acknowledged .
two ways : a . We report issued by the certificate , and b . issuing foreign institutions ; rail Fei 6000

7 certification data and process
authentication information
1 The application for approval of the products of the manufacturers and the application of the authenticator and the contact address .
2 will be provided to the user ' s authentication product installation and copy the owner ' s manual . ( If the product is not yet a user manual , may be provided a draft copy of the relevant content .
3 . Electrical Schematic Diagram of the product and the original job ) ( Daniel ) .
4 relating to the products of the working oscillation frequency table , the table should be included in the signal propagation path and the corresponding oscillation frequency .
5 . It should be noted that some other product characteristics .
1 . Except as specially stated , the foresaid information shall be available in English .
No . 2 for a variety of plow for his mount , respectively provided for each model of information
3 . If you are applying for the approvals , please attach the spent products with different types of similarities and differences between
the authentication process .
1 sample
2 Product Information
3 Form of application
4 and make a contract
5 First Arrangement
The test
7 - reports
8 and the rest of the payment arrangements

8 - certification
5 working days

Previous:Australia A - Tick

Next:Australian RCM authentication

return